WHY AND WHERE TO USE PLUS HANDPIECE?
The PLUS handpiece is the ultimate evolution of the Magnetic Mallet project.
It’s a handpiece delivering higher forces which are supporting the surgeon in doing surgery on the lower jaw bone (with a tougher bone density) and in the extraction of impacted teeth or roots.
The Plus handpiece is supplied on request.
HOW DOES IT WORK?
The PLUS handpiece, thanks to its specific design, delivers a calibrated pulse able to convey a 30% higher force compared to the forces delivered by the standard handpiece, supplied with Magnetic Mallet.
These increased forces, applied in an optimal timing, allow the surgeon to get an easy penetration into the bone mass, even in the higher density part. That way the plastic deformation will be obtained in the best way, and the extraction of impacted teeth and roots will be obtained in less invasive way, too.
WHICH ARE THE ADVANTAGES USING PLUS HANDPIECE?
Thanks to its peculiarities the surgeon, with this handpiece, can carry out a surgery on the lower jaw or extracting impacted teeth and roots in a riskless way, optimizing the time for the surgery completion.
The surgeon, time by time, will choose the right force to be applied in relation to the surgery to carry out and to the results he wants to obtain; the patient will sense the surgery in a less bothersome and invasive way.
Moreover, the PLUS handpiece, having the same features of the standard one, allows the surgeon to always have at his disposal a second handpiece if needed.
WHY AND WHERE USING CROWN REMOVER HANDPIECE?
The accessory on request Crown Remover handpiece can be considered a further evolution of the Magnetic Mallet appliance and it’s intended to remove crown and bridges.
The handpiece, which can be sterilized by autoclave, can be used simply coupling it to the power supply, through the same connector entry used for osteotome handpiece; that way the surgeon can use Magnetic Mallet also when a crown or a bridge has to be easily and safely removed.
Thanks to the Crown Remover handpiece the doctor will avoid any milling of the crown or of the bridge, saving time and guaranteeing a higher comfort to the patient.
The Crown Remover handpiece is supplied in its briefcase containing also 3 hooks and their dedicated container which can be sterilized by autoclave.
The crown remover hooks can be purchased at ASA Dental with the following reference numbers: 2306 / 2307 / 2308
HOW DOES IT WORK?
This handpiece works on the same principle of the osteotome handpiece, but the power is applied in reverse, and it conveys a calibrated pulse which is adjusted according to the selected power supply force (1-4).
If we compare the force, applied by the Magnetic Mallet to remove the crown or the bridge, to the one applied by the manual practice, we could get a triple force which is expressed in highly reduced timing. In fact, by the manual practice you can get a force applied in thousandth seconds while with Magnetic Mallet you can achieve a higher force applied in millionth seconds.
THE ADVANTAGES IN USING CROWN REMOVER HANDPIECE
Crown Remover handpiece features allow you to achieve the deformation and the breaking of the retention cement with the consequent loosening of the crown or of the bridge to be removed in an easier, faster and safer way.
We also want to point out that the manual practice, irrespective of the practitioner’s ability, is always more complex for the practitioner and more traumatic for the patient.
It will always be up to the surgeon to verify the feasibility of the surgery with Magnetic Mallet with relation to the abutment fragility.